Congratulations
on buying the finest Fuel Pumps, Regulators, Fittings, A-N hose,
& ends ever made! Please be sure to properly install and
assemble the pumps, regulators, hoses and fittings. You can
find the complete instructions in the technical information
section of this web site.
When plumbing your vehicle or boat, be certain to keep the pumps,
regulators and hoses as far away from heat sources like the
exhaust system, as possible. Secure your lines at various intervals
in order to prevent them from moving.
A few drops of regular motor oil on the threads of any adapter
will make installation and removal easier. The seal of the hose
end is made by the contact with the 37 degree flare. Be careful
not to over-torque the hose end when installing the adapter.
Please refer to the torque specifications.
A word about anodizing.. At Product Engineering, we use a process
called "Brite-Dip", but the anodizing process is not
an exact science like painting or plating. The colors will vary
from batch to batch, plus the sun, heat, & time will all
cause some fading. Various alloys of aluminum will anodize with
different hues.
|
